Re: [80] Re: Big end bearings

• To: <80scool@xxxxxxxxxxxxxxx>
• Subject: Re: [80] Re: Big end bearings
• From: "martin lee" <mail@xxxxxxxxxxxxxxxxxxxxxxxxxx>
• Date: Sun, 15 Dec 2002 00:21:17 -0000
• Mailing-list: list 80scool@xxxxxxxxxxxxxxx; contact 80scool-owner@xxxxxxxxxxxxxxx

Hi Guys

While we are on this popular topic again I was just wondering had any of you heard of any adverse reports on the Toyota shells used to replace the original bearings. A few years have passed since some replaced theirs and I was just wondering if the fix has proved reliable.

Secondly someone wrote to me a while back and said that they were using ACL bearings but that they only came in one size? Although I have no experience of ACL I would have thought it impossible to get accurate (near factory) clearances if this were the case.

Cheers


Martin
HDJ80 93


[Non-text portions of this message have been removed]


- Our very own LCOOL web site is at http://www.lcool.org
- To unsubscribe, send an email to:
80scool-unsubscribe@xxxxxxxxxxxxxxx
- To place an advert in LCOOL Trading Post send an email to 
lcool_classifieds@xxxxxxxxxxx



 

Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/ 

• References:
  • [80] Big end bearing
    • From: Joseph Alexander Uy <alexuy22@xxxxxxxxx>
  • Re: [80] Re: Big end bearing (personal opinion)
    • From: Willem-Jan Markerink

• Prev by Date: Re: [80] Several Questions (long)
• Next by Date: RE: [80] Several Questions (long)
• Previous by thread: Re: [80] Re: Big end bearing (personal opinion)
• Next by thread: [80] 1FZ Top end work
• Index(es):
  • Date
  • Thread