[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [3FE] Vaccum solenoid transfer switch 88-90 fj62
thank Al Romero
----- Original Message -----
From: Al Romero <cruiserfj60@xxxxxxxx>
To: <3FE@xxxxxxxxxxxxxxx>
Sent: Tuesday, May 14, 2002 6:30 AM
Subject: Re: [3FE] Vaccum solenoid transfer switch 88-90 fj62
> And for those who want to go non stock.... I think this was posted by you
> earlier Keil....RIght?
> Did it work out ok?
> -A-
> ---------------------
> ok this is the solution
> parts:
> mac 35a-aaa-ddba-1ba valve 12v-qty2 total 34.00
> arrow asp-1 exh muffler-qty 2 total 3.20
> 28-4-2 parker fitting-qty 4 total 2.44
> total for two complete valve assembilies 39.64
> extra standard rubber vaccum line like is already on the truck.
>
> the mac valves have three slots for the fittings
> i used teflon tape to get a good seal
> the exhaust fitting goes in the top numbered 3
> install the parker fittings in the other two screw intakes
> the line from the manifold goes into the fitting that is marked 1
> on the mac valve
> the line from the transfer goes into fitting marked 2
> cut the old wire leads off and connect the mac valve leads
> connect the vaccum lines
> for the mounting bracket i used a piece of alum. and formed
> a bracket.
To unsubscribe from this group, send an email to:
3FE-unsubscribe@xxxxxxxxxxx
Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/
|
